1-888-489-3880

HOME PAGE

MIATA ROLL BAR

CSC MIATA ROLL BAR ON THE ROAD

Roll Bar $485.00
Plus Optional installation at our facility $350.00

Nothing really tells the story of a product better than recomendations from previous customers. The following are exactly that.
----- Original Message -----
From: boggycreek Manitoba.com
To: ralph@cscracing.com
Sent: Thursday, April 24, 2008 11:03 PM
Subject: Miata Rollbar Pics

Hi Ralph
Here are some photos of the rollbar,Doug @ Benito Service Center said you were very helpful with advice over phone he did a real nice clean job of install as you did with manufacturing bar we are very happy with end result I will be sure to mention your name to anyone looking for a rollbar .Thank You again for your prompt friendly service.
Armand

Ontrack flip and a shot after it's returned to its wheels

CSC Racing Products has been manufacturing and installing Road Racing Cages for ASN-FIA, CASC, SCCA and CARS sanctioned events for many years. We can prep any vehicle for a roll cage or roll bar.

Some we require the vehicle for the installation, others we build from existing jigs. The Miata happens to be an item we build from jig regularly as a roll bar or a full cage.

The flip featured above happened at a SOLO I event at Shannonville Speedway in June, 2001. The SOLO Event Report said this,
"[the] Miata entered the turn too fast...the car was flipped over...the driver...had a minor scrape injury...the [car] driver's side of the windshield collapsed, and the [CSC Racing Products] roll bar had a hard scrape at the point over the driver's head".

Once again, when it comes to safety...we are the experts!

and this note from Jeff: I recently installed a CSC rollbar in my Miata, for track days and autoX events. I thought you might like another picture for your website. I've already had a couple of inquiries about where I got the bar from. I'm very happy with the bar - very sturdy, and well constructed! As usual, a picture and our customers words usually say it best.

FREQUENTLY ASKED QUESTIONS AND ANSWERS:

Q. Does your bar allow full movement of the seats? I'm tall and I need every last centimeter of seat travel and recline adjustment.
A. There is a slight restriction in rearward movement as the main hoop mounting position is on the floor behind the seat, the recline is not restricted by the bar.

Q. Does your roll bar bolt in?
A. yes, it is entirely bolt in and works with all models. All you will have to cut is the carpet and a little bit of the back partial shelf to allow the rear diagonal bars to run into the trunk area.

Q. With your bar, can I still put the convertible top up with no problems?
A. yes the bar allows full movement of soft top and also allows use of a hard top.

Q. Installed properly, will your bar pass SCCA tech?
A. the bar is a four point with a lateral brace and harness bar. The main hoop and rear diagonals are DOM material, diameter of 1.75" wall thickness .120
the lateral brace and harness bar are DOM material 1.50" diameter wall thickness of .120, plates are 3/16" thick a minimum of 20 square inches and the bolt in hardware is grade- 8 7/16" diameter three bolts per plate at main hoop and 4 per plate at rear diagonals. You will need to check your SCCA spec against the description provided to determine compliance.

CSC ORIGINAL MIATA INSTALLATION

back to the top